Phones answered 24/7Nashua, NH
Call (833) 751-2102
Serving Hillsborough County

Ice dam removal and repair for Nashua eaves

Ice is cleared from the eave safely and the water path behind it is repaired, so the next thaw does not find the same gap.

  • Leaks, flashing and tear-offs
  • Ice dams and nor'easter snow
  • Older roofs on tight lots

Get a fast quote

Fastest: call (833) 751-2102. Or send this and we call you back.

Ice Dams

Ice Dam Removal and Repair: what it covers

Quick answer

An ice dam is a ridge of refrozen meltwater that builds at the eave when heat escaping from the attic melts snow higher up the roof. Removal clears the ice without damaging the covering, and repair finds the warm-air leak and the missing insulation or ventilation behind it, so the dam does not return with the next storm.

Ice Dam Removal and Repair illustration for Nashua, NH

A nor'easter leaves a deep layer of snow on the roof, the sun comes out for a day, and by the next morning there is a bulge of ice along the eave with water backing up under the shingles. That ridge is an ice dam, and in New Hampshire it is one of the most common winter roof calls. The water it holds does not simply drip straight down. It sits, works under the courses and reaches the walls and ceilings below.

The mechanism is well understood even though it looks random from the ground. Heat rising from the living space leaks into the attic, warms the underside of the roof and melts the snow above it. That meltwater runs down to the overhang at the eave, which the house does not warm, and freezes there. Each new thaw adds to the ridge until it climbs far enough up the slope to push water past the shingles.

Nashua Roofing treats an ice dam as two problems. The ice already there has to come off safely, and the cause in the attic has to be fixed, or the same eave will build the same dam the next January. This page covers both halves, and the attic ventilation page goes deeper on the cause.

Service area
Nashua & Hillsborough County
Availability
Phones answered 24/7
Warning signs

Signs you need ice dam removal and repair

Keep off the roof while ice or snow covers it, and never stand under a dam that is being cleared, because pieces fall without warning. Do not use salt or hot water against the shingles, since both can lift granules and strip the surface. Do not punch holes in an ice dam to drain it, because the water behind it will find the easiest route into the wall. Call (833) 751-2102 and ask for a roofer to clear the eave safely.

  • A thick ridge of ice hanging over the gutter along the lower edge of the roof
  • Water stains on the wall or ceiling directly below the eave rather than under the ridge
  • Icicles long at the eave and short or absent further up the slope
  • Bubbling or peeling paint on the soffit and fascia in a horizontal line
  • Shingle edges lifted or pushed up where water has been forced under them
  • Snow melting off the upper roof while the lower eave stays white
  • Bare, dark patches on the roof surface in cold weather where heat is escaping
Job stories

Typical jobs for ice dam removal and repair

Typical job
Illustration: A typical ice ridge at the eave after a cold week

A typical ice ridge at the eave after a cold week

What homeowners notice
A band of ice has formed along the lower edge of the roof after several days in the low twenties with snow still on the slopes, and water is marking the top of a wall in the room below.
What we do
The lowest snow is drawn down from the ground with a plastic rake, and the ice is left to thaw rather than chipped. The attic is then checked for frost, a buried soffit vent and an unsealed hatch above the affected room.
What to expect
A written plan separates the clearing from the lasting work: sealing the openings in the ceiling, bringing the insulation to depth over the wall plate and reopening the soffit channel with baffles.

Options

Types and options for ice dam removal and repair

A ridge of ice at the eave

The most common form: a band of ice a foot or more deep along the gutter line, backing water under the courses. Clearing it is the first step, and the attic work is what keeps the next band from forming.

Ice in valleys and at dormers

Valleys concentrate meltwater, so ice builds faster where two slopes meet. Clearing is slower there because the material lies in a narrow channel and has to be kept intact while the ice is lifted away.

Icicles without a full dam

Long icicles can hang from a gutter with little water getting under the shingles. They are still a sign of heat loss and a loaded gutter, so the attic is checked in the same way before the homeowner decides that nothing is wrong.

Still stuck? We pick up 24/7.

If it's an emergency, call now. For non-urgent ice dam removal and repair, send the form and we'll call you back.

Why does an ice dam form on a warm day?

Snow melts on the warm upper roof and refreezes at the cold eave, and a single day of mild sun is enough to start the meltwater moving.

Heat is the engine. Warm air from the living space passes into the attic through gaps, and it warms the roof underside enough that the snow above begins to melt, even in the middle of a cold week. The meltwater runs down to the overhang, which the house does not warm, and freezes there.

Each freeze and thaw pushes the water a little farther up the slope, so the dam grows until it reaches a point where water can get past the edge of the shingles. A chain of dams can keep a house leaking all season if the heat keeps reaching the roof.

Can I chip the ice off myself?

You can rake snow off from the ground, but chipping at ice on the roof is dangerous and it damages the covering.

Chisels, axes and pry bars cut through shingles, lift the edge of the underlayment and strip the granules that protect the roofing from sun. The damage shows up the following summer, and the leak it causes is often blamed on the ice. Stand on the ground, not a ladder, and use a long raking tool for snow only.

Ice on a steep slope can slide and fall without warning. The rule is simple: stay off the roof while it is iced, and let a roofer clear the eave from a safe position with the right equipment.

Does more insulation alone stop ice dams?

Insulation helps, but only as part of a plan that also stops warm air leaking into the attic and keeps the attic breathing.

Adding insulation to a cold attic floor reduces the heat that reaches the roof, but a leaky ceiling can still carry warm, moist air into the attic, and insulation does not stop that. Air sealing at the top plates, around the chimney and at light fixtures is usually the first step, before more material goes down.

Ventilation carries away the heat that still gets through. The attic ventilation for ice dams page explains how the intake and the exhaust are balanced so the roof deck stays close to the outside temperature.

Will the ice damage my gutters?

Often, yes. Ice heavy enough to hold the gutter's shape can pull the fascia and bend the hangers, and water backed into the trough can rot the wood behind it.

A gutter loaded with ice is a weight problem, and a gutter that has come loose is a water problem. Hangers that have pulled out of the fascia are refixed, and damaged sections are replaced so the gutter drains toward the downspout rather than back toward the wall.

A roofer who clears an eave looks at the gutter at the same time, because a trough that cannot drain gives the next dam something to build on. The gutter and downspout repair page covers the details.

What if water has already reached the house?

Act quickly. The ceiling and wall below the stain should be checked for wet insulation and soft drywall, and the water path traced back to the eave.

Stains that appear overnight after a thaw are the first sign. Put a container under the drip, move furniture and rugs, and keep the room ventilated so the wall can dry. A ceiling that bulges or sags should be looked at before anyone stands beneath it.

Once the source is found, the damaged insulation and sheathing are replaced and the area is allowed to dry before it is closed up. Painting over a stain before the wall is dry hides the next leak rather than fixing the first one.

Our process

How our ice dam removal and repair visit works

  1. Find the dam and the warm spot

    The first step is to see where the ice sits and how deep it runs. A roofer notes which eave holds the dam, whether the attic is warm near the ridge, and whether the gutter is buried, because each of those points toward the source of the heat.

  2. Clear the eave without damaging it

    Safe removal uses a long raking tool from the ground or a secure edge, never a chisel or a steel bar, since those cut into shingles and tear off granules. Loose snow comes down first, then the ice is cleared in controlled sections so the slope keeps its covering.

  3. Open up the attic

    The attic is checked for warm air rising through the ceiling. Bath fans vented into the roof space, uninsulated recessed lights, gaps around the chimney and open plumbing penetrations are the usual suspects, and each one is noted with its location.

  4. Seal the path and restore the insulation

    Gaps that let warm air rise are sealed, and insulation is brought up to a continuous layer across the ceiling joists. Sealing the penetrations stops the warm air that feeds the dam at its source, which is the only lasting fix for the eave.

  5. Check the eave and the water path

    Once the ice is off, the shingles and underlayment at the eave are checked for water damage and for any lifting. Damaged underlayment is replaced, and the gutter is refitted so meltwater can leave the roof rather than sit on it.

Hillsborough County

Why ice dam removal and repair is different in southern New Hampshire

Ice dams are a particular feature of southern New Hampshire winters. The thaw-and-refreeze pattern after a storm is what builds them, and a stretch of snow followed by a mild spell is the usual setup. The ice dam guide covers the wider pattern across the region.

In Nashua, many houses have attics that were finished or partly finished over the decades, with knee walls, dormers and recessed lights that let warm air into the roof space. Older stock from before 1970 often has the least air sealing, so when a dam forms on an older Nashua roof the attic is usually where the fix begins.

Tight lots add a practical problem. Clearing an eave on a house that stands close to the sidewalk means managing the snow and ice that come off the roof, and a crew will plan where that material can safely land so passersby and parked cars are not struck.

Related

Attic Ventilation for Ice Dams

Balanced intake and exhaust keep the roof deck cold, so snow does not melt above the eave and refreeze there.

Snow Load Roof Inspection

A roofer checks the framing, the deck and the ridge line after heavy snow, and says what must come off now and what can wait.

Gutter and Downspout Repair

Sagging troughs, loose hangers and blocked outlets are fixed so meltwater runs away from the house rather than into it.

Leak Diagnosis and Flashing Repair

The leak is traced to its real entry point, usually at flashing or an eave edge, and the metal is rebuilt in the right order.

Guides

Read before you book

FAQ

Ice Dam Removal and Repair FAQs

Will the ice dam go away on its own?

Sometimes, if the weather turns mild and stays mild for several days. But water behind the dam has usually already worked under the shingles and into the house, so waiting is a gamble with the ceiling. The heat source in the attic is still there and will build the next dam.

Are ice dam repairs covered by homeowners insurance?

Coverage depends on the policy and on the damage it caused, so it is a question for the insurer. The state regulator is the New Hampshire Insurance Department. Keep photographs of the ice and of any stains before the eave is cleared, since those are what a claim will rely on.

Should I run heat cables on the roof?

Heat cables are a common answer, but they only melt a channel through the ice and they draw power all winter. They do not remove the cause, and a poorly fitted cable can damage the gutter. Air sealing and insulation are the lasting fix, and a roofer can say whether a cable has a limited role.

How much snow is too much to leave on the roof?

There is no safe depth to print, because it depends on the pitch, the age of the framing and how wet the snow is. Rake the snow back from the eave while standing on the ground, and call for help if it is out of reach from there.

Can the same eave build a dam every winter?

It can, which is why the attic is checked. If warm air keeps reaching the roof, the same overhang will keep freezing. Once the leak path is sealed and the insulation is restored, the eave usually stays clear for the rest of the season.

Do vents stop ice dams on their own?

Vents help, but only when the ventilation is balanced and the insulation is in the right place. Soffit vents covered by insulation blown into the eave do the opposite of what is needed. The attic ventilation page has the detail on intake and exhaust.

WhatsApp