Eave band clearing
The most common form of the work: a band of snow cleared along the lower roof and the eave to stop the dam. It is quick and targeted, and it leaves the covering beneath the rest of the snow undisturbed.
Snow is cleared from the lower roof and the eave in a controlled way, and deep drifts are assessed rather than shoveled.
Fastest: call (833) 751-2102. Or send this and we call you back.
Roof snow removal clears heavy snow from the lower roof and the eaves in a controlled way, so meltwater cannot build an ice dam and the load on the framing is reduced. It is done from a safe position with equipment made for the job, and deep or wet drifts that cannot be cleared safely are measured and left for inspection.
After a heavy snowfall the first instinct is to clear the roof, and the instinct is understandable. Snow on a roof adds weight, feeds ice dams and can slide off onto a walk or a car. The way snow is removed matters as much as the decision to remove it. Shoveling from a ladder or from a snow-covered roof is one of the most common ways people get hurt in winter, and a roof damaged by careless clearing can leak long after the snow has gone.
In Nashua, snow often falls in long wet spells rather than as light, dry dusting, and a wet, heavy layer is the hardest to move. Snow left on the eave melts, refreezes and builds the ridges of ice that push water under the shingles. Clearing the lower few feet of roof, where the dam forms, does far more good than clearing the whole slope, and it is much safer.
Nashua Roofing clears roofs with the work set up from a safe position, and it leaves alone any drift that is too deep or too unstable to move. The sections below explain what gets cleared, what gets left, and how to handle snow yourself without climbing.
Snow removal is a common cause of winter injury at home. Never climb a ladder onto a snowy or iced roof, never use a shovel on the roof surface, and never stand under a roof edge while snow is sliding. Do not use a metal tool on the shingles or the gutter. Keep people and cars out of the drop zone below the eave. Call (833) 751-2102 to have a roofer clear a band of snow from a safe position.
The most common form of the work: a band of snow cleared along the lower roof and the eave to stop the dam. It is quick and targeted, and it leaves the covering beneath the rest of the snow undisturbed.
Where the roof is low enough to work on safely and the snow is light and dry, a fuller clearing may be sensible. The crew checks the covering and the access first, and clears only when the set-up is safe.
Drifts built against a wall, dormer or valley carry the heaviest load and are the most likely to stress the structure. They are measured, and removal is planned with care, since a sudden change in weight can strain the framing.
Tell us what's happening and we'll tell you honestly whether it's a quick fix, and what roof snow removal should cost.
You can rake the lower few feet from the ground with a long tool. Anything that needs a ladder or a step onto the roof is work for a roofer.
A roof rake used from firm ground can pull snow off the lower slope without anyone climbing. It should be used gently, because jerking at the edge can bend the gutter or scrape the shingles beneath, and it should not be used on an edge that is iced or has a loose gutter.
A shovel on a roof is a different matter. A person standing on snow can slip, the roof can give under the weight, and a shovel scrapes off the granules and tears the edge of the covering. If the work needs a ladder, a step or a person on the roof, call a roofer.
The eave is the coldest part of the roof and the place where meltwater refreezes. Clearing the eave band cuts off the supply that builds a dam.
Heat escaping from the attic warms the upper roof, so the snow above the warm zone melts. The water runs down to the eave, which sits outside the warm zone, and freezes. Removing the snow from the lower band stops water reaching that cold edge, so the ridge of ice has nothing to grow from.
Clearing does not stop the heat that caused the problem, and the ice dam removal page covers the attic side. Clearing is the short-term step that keeps the eave open while the lasting fix is planned.
It can, especially where drifts build against a wall or over a valley and the framing is old or has been altered. The damage is often a slow sag or a crack rather than a sudden collapse.
Snow loads framing a little each time, and an older roof that has taken many heavy storms may show a sag along a ridge or a crack at a rafter notch. Those signs are checked before the next storm, through the snow load roof inspection.
The drift is the part of the roof most at risk. Where it is deepest and the structure is weakest, the roofer leaves it alone and says so, rather than risk a sudden change in load on the day.
Clear snow from doors, steps and outside vents from the ground, and do not climb onto the roof to reach a vent that is buried.
A furnace or boiler vent blocked by snow can cause problems for the appliance, so it is kept clear whenever it can be reached safely from the ground. Clearing a path to the outdoor meter and the electrical service at the same time keeps those points accessible in an emergency.
Snow around a door is cleared from outside, and the step is checked for ice. Salt is used sparingly on the steps and walks, and it is kept away from plantings and the metal of the gutters.
The depth and wetness of the snow are judged from the ground. The roofer notes where it is deepest, how it sits over the eave and valleys, and whether the access allows a safe set-up for the work.
Equipment is placed on firm ground with a secure base. Where a ladder is needed, it is set and held properly, and the crew does not work on a snow-covered slope without the fall protection the roof calls for.
The lower few feet of snow, where the dam forms, is cleared first, using long tools that reach the eave without stepping onto the roof. Snow is pulled down in controlled sections so it lands clear of walks, cars and the foundation.
Deep or wet drifts over valleys and dormers are measured and left in place where clearing them would be unsafe. The depth and location are recorded, and the roofer says whether an inspection is needed before the next storm.
The snow that came down is cleared from walks, the drive and the entrance so the work does not create a hazard. The gutters are checked for damage from the weight of the snow and for ice that has formed in the trough.
Snow removal in Nashua has to fit the lots. In the Tree Streets, houses stand close to the sidewalk, and snow dropping from the eave can land on the public walk. The crew plans the drop zone and keeps the walk clear before any snow comes off the roof.
Wet storms show how heavy the load can be in this part of the state. A snowfall of that kind is when the eave band and drifts need attention first. Regional storm history is covered in the nor'easter guide.
On the Massachusetts side of the line, and on streets close to the river, buildings sometimes share a wall or a drive. Snow removal is planned so that snow from one roof does not block a neighbor's entrance or drive.
Not sure if you're covered? Check your ZIP code.
A roofer checks the framing, the deck and the ridge line after heavy snow, and says what must come off now and what can wait.
Ice is cleared from the eave safely and the water path behind it is repaired, so the next thaw does not find the same gap.
A photographed, written record of a roof's condition, covering what was seen, what was not, and what is likely to need doing next.
After a nor'easter or a wind event, the roof is checked for lifted courses, displaced flashing and hidden damage, and the findings are recorded in writing.
Snow load is the weight a roof carries, measured in pounds per square foot of roof surface.
The aim is to clear the lower band where the dam forms and to deal with deep drifts over valleys and dormers. Clearing the whole roof is rarely necessary and adds risk, so the roofer chooses the area on the day.
It helps for a while by removing the snow that melts and feeds the dam. It does not stop heat leaking from the attic, so the cause is still there. The attic ventilation page covers that side of the problem.
Salt can be used sparingly on walks, but it should be kept away from plantings and from gutter metal, and it should not be thrown toward the roof edge. Sand is a gentler choice for steps.
Often it is, but not always. A deep drift over a valley or against a dormer carries a heavy load, and the roofer will say whether it should be assessed sooner. The snow load inspection page explains what that assessment looks for.
Snow sliding in sheets can injure people and damage cars and gutters below. The drop zone is kept clear, and a snow guard can be considered on a roof that regularly sheds snow onto a walk or drive.
Yes. A trough loaded with snow or ice can pull from the fascia, and a downspout can crack. The gutter and downspout repair page covers the checks and the fixes.