Phones answered 24/7Nashua, NH
Call (833) 751-2102
Guide

How an ice dam forms, and why this area's houses build them

How ice dams form at the eaves of southern New Hampshire roofs, why older Nashua attics build them, what storms add and what a lasting repair covers.

Illustration for the guide "How an ice dam forms, and why this area's houses build them" (Nashua, NH)
Short answer

An ice dam is a ridge of ice at the eave that holds back meltwater, which then runs under the covering and into the house. It forms when heat escapes from the attic, melts the snow above the warm roof and refreezes at the cold edge. In Nashua the pattern is common because of old attics, dense housing and winters with repeated thaws.

Key takeaways

  • An ice dam needs two things at once: heat escaping through the roof into the attic, and a cold eave where meltwater refreezes.
  • A large share of Nashua homes predate 1970, and many of those attics were never insulated or ventilated to modern standards.
  • Storms bury the roof and then the melt-and-refreeze cycle that follows builds the dam over several days.
  • The cause is in the attic more often than on the surface of the roof, so the lasting repair starts above the ceiling.
  • Raking snow from the ground is a safe first step, and chipping ice from the roof is not.
  • A repair that seals, insulates and ventilates the attic addresses the source, while clearing the ice only treats the symptom.

What is an ice dam, and how does it form?

An ice dam is a band of refrozen meltwater at the lower edge of a roof, built up from heat that rises out of the house.

Snow lying on a roof melts from the bottom up when the roof surface is warmer than freezing. If the attic below is warm, heat conducted through the ceiling and the framing keeps the roof surface above freezing even on a cold day, and the snow melts from underneath. The water runs down the slope until it reaches the eave, where the roof overhang is exposed to the outside air and nothing keeps it warm.

At the cold eave the meltwater freezes. Each new run of water freezes on top of the last, and the ridge of ice grows upward and backward until it holds a pool of liquid water behind it. That pool has nowhere to go but under the shingles, where it can reach the sheathing, the wall plate and the ceiling below.

The mechanism is general roofing knowledge rather than a local finding. What makes the problem worse in a particular house is the amount of heat moving into the attic and the number of days the roof stays cold enough to refreeze the melt.

Why do older Nashua houses build dams so readily?

The housing stock carries the conditions that produce the heat leak: old attics, tight rooms under the roof and little ventilation at the eave.

A City of Nashua housing study put about 60 percent of the city's homes up before 1970. Those houses were built to standards that did not expect a continuous air barrier at the ceiling, and many of their attics were later insulated from above without anyone adding ventilation. The result is an attic that runs warm in winter and a roof that melts from beneath.

The neighborhoods closest to the center are older still. A city neighborhood analysis from 2012 found that most of the Tree Streets area was built before 1900, with houses standing within ten feet of the street. Those roofs are often steep, cut into several planes and close to their neighbors, which leaves less room for an airflow path and more chances for heat to find its way up into the attic.

Median build-year estimates for the city cluster around the mid-1970s, but the sources that give them disagree, so the safer statement is that the stock is mostly old and mixed. Whatever the exact year, an attic built before modern air sealing is the usual starting point for an ice dam on these streets.

What do storms and thaws add to the problem?

A heavy storm buries the roof, and the thaw and refreeze that follow give the dam the days it needs to grow.

The January 2011 nor'easter dropped 14 to 21 inches across western and central Hillsborough County, with about 20 inches falling in 24 hours across southern New Hampshire, according to the National Oceanic and Atmospheric Administration storm events record. A roof carrying that much snow holds a large reservoir of water once the first warm day arrives, and every degree of warmth in the attic speeds the melt beneath it.

The pattern that matters is repetition rather than a single event. A week of days above freezing followed by nights in the teens lets the water run, freeze and run again, and each cycle adds a layer of ice at the eave. A single warm afternoon after a storm usually does less harm than three such cycles in a row.

No local statistic on ice dams in Nashua was found in the sources reviewed for this page, so no claim is made about how often they occur. What can be said is that the conditions which build them, a heavy storm followed by repeated thaws over old attics, are the conditions this area receives.

Why does the attic matter more than the roof surface?

The leak is driven by heat and air moving upward, so the attic holds the fix as well as the cause.

Warm, moist air rises from the living spaces through every gap in the ceiling: around light fixtures, at the attic hatch, along the top of interior walls and through the chase of a chimney. Each of those openings carries heat into the cold space above, and each contributes to the melt that starts the dam. Sealing them is usually the most effective single step.

Ventilation is the other half. Soffit intake vents let cold air enter at the eave and carry heat out through the ridge, which keeps the roof deck near outdoor temperature. Where a soffit has been covered by insulation or painted shut, the air path is broken and the eave stays warm enough to melt. Baffles keep insulation away from the vent so that the airflow is not blocked at the edge.

Insulation depth over the wall plates matters too. Insulation that stops short of the outside wall leaves a cold strip exactly where the dam forms. Bringing the depth up to the level of the rest of the attic closes that gap, and it is worth checking during any attic visit rather than assuming it is already done.

What does ice damage look like inside the house?

Water from a dam usually shows first as a stain at the top of a wall or a bubbling ceiling near an outside corner.

The first sign is often a stain on the ceiling of the top floor, or a patch of paint that has begun to lift along the outside wall. The mark may appear days after the thaw, because the water has to soak through insulation and framing before it reaches the finish. A stain near a light fixture on the top floor is a common sign of a dam that is feeding water into a fixture box.

Stains that grow after each thaw, or that show up at a corner where two walls meet the roof, point to the eave rather than the surface. Water tends to travel along the rafter and across a bay before it drips, so the mark may sit well away from the actual leak. That is why a visit should begin in the attic, following the wet line upward.

Mold can start within a few days in an attic that stays damp, and it is easy to miss from the living space. Anyone who sees a musty smell or dark staining on the underside of the sheathing should note the location and ask for it to be checked as part of any ice dam visit.

What can a homeowner do safely in the middle of a freeze?

Rake the lowest snow from the ground, keep the eave clear and do not climb onto the roof to chip ice.

A roof rake with a plastic blade, used from the ground, can draw the lowest few feet of snow down before it compacts. Removing the snow at the eave reduces the reservoir that melts into the dam, and it does so without anyone standing on a slope that may be slick. Keep the rake gentle, because a metal blade can scrape the covering.

Chipping at ice with a tool from a ladder or the roof is the most dangerous option and rarely works, since the ice is bonded to the surface and the covering can be cracked in the process. Calcium-based melt products applied from the ground can open a channel for water, but they should be placed with care so that they do not damage plants or the finish of gutters.

Call (833) 751-2102 if water is coming into the house or the ice is growing across the eave. The call can set out a plan for the immediate step and arrange an inspection, which is more useful than a homeowner trying to solve a roof problem alone in the dark.

What does a lasting repair cover?

A lasting repair seals the attic, brings the insulation to depth, restores the ventilation and deals with the flashing and underlayment at the eave.

The sequence matters. Air sealing comes first, because it stops the heat that feeds the dam. Insulation follows, brought to depth over the wall plates and around the hatch. Ventilation is then checked and restored, with intake at the soffit and exhaust at the ridge, so that the roof deck stays close to outdoor temperature in winter.

The roof itself is looked at last. Where the dam has damaged the sheathing or lifted the covering, the affected boards are replaced and the eave is flashed and underlaid in a way that sheds water when it does get under the surface. Ask that the findings record the attic conditions, the boards replaced and the flashing added, with photographs located against the house.

A lasting repair also changes what happens in the next storm. A house that has been sealed and vented still melts snow, but the melt runs off the eave rather than backing up behind a ridge of ice. That is the outcome the work is meant to produce, and it is the test a written findings report should be able to show.

Frequently asked questions

Are heat cables a fix for ice dams?

They can keep a channel open at the eave, but they treat the symptom and draw power all winter. A lasting repair deals with the attic heat that builds the dam in the first place, and cables are best understood as a temporary measure while that work is planned.

Should I use a roof rake or hire someone to clear the snow?

A roof rake used from the ground is a reasonable step for the lowest few feet. Anything that requires standing on the roof should be left to a crew with the right equipment and the fall protection to use it.

Will a dam come back every winter?

It can, if the attic heat and the ventilation problem are left as they were. A dam is usually a sign that the house is losing heat upward, and it returns when that flow continues. Sealing and venting address the flow rather than the ice.

Is there a Nashua statistic on how often ice dams occur?

None was found in the sources reviewed for this page, so no figure is given. The page describes the conditions that produce dams, which are the things a visit can check directly in your own house.

This guide is general information for Hillsborough County homeowners, not a substitute for an on-site inspection. Prices are estimates. See our disclaimer.

Need help today?

Call any hour and explain what is going on. You get a clear price before any work starts.

Keep reading

More guides

WhatsApp